| Network |
| PPPoE |
If your ISP provides Dynamic IP with authentication by username and password, type all PPPoE information in this part. When using the PPPoE function, you need to turn on the DDNS or IP Notification function at the same time.
IP address :
The IP address obtained at the PPPoE connecting with network.
User ID :
Enter the user ID for authentication necessary for PPPoE connections. Type it up to 64 characters.
Password :
Enter the password for authentication necessary for PPPoE connections. Type it up to 32 characters.
Re-type password :
Re-type the password to confirm.
Obtain DNS server address automatically :
Select this to obtain the address of DNS server automatically.
Use the following DNS server address :
Select this when you set the fixed address as the IP address of DNS server.
-
Primary DNS server :
Enter the IP address of the primary DNS server.
-
Secondary DNS server :
Enter the IP address of the secondary DNS server.
Note :
1. PPPoE (Point-to-Point Protocol over Ethernet): PPPoE is a network protocol for encapsulating Point-to-Point Protocol frames insider Ethernet frames. PPPoE connection is used mainly with ADSL service where individual users connect to the ADSL transceiver (modem) over Ethernet work. It also widely used in XDSL (digital affiliate line such as ADSL, VDSL or SDSL).
2. Reboot the IP Camera after the network setting has been made.
3. The IP Camera with Intelligent IP Installer can’t be founded after turning on the PPPoE and reboot.
|
|
Return to Help main page
|
|